Solar-Log 2000 User Manual

183
Configuration Menu
16.16 System Confi guration
The Configuration | System menu has the basic settings for the Solar-Log™ and contains the following
tabs:
•
Access control
•
Language/Country/Time
•
Display
•
Licenses
•
Firmware
16.16.1 Access control
Access protection for different parts of the Solar-Log™ can be configured in this menu. The following
sections can be restricted with pin codes or passwords
•
Access protection for the display
•
Access protection for the browser menu
•
Displaying advanced configuration
Access protection for the display (only Solar-Log 1000, 1200 and 2000)
A pin code can be activated to restrict access to the Solar-Log™'s display. The pin code may contain a
maximum of 8 numerical digits.
Access at the display can be restricted for the entire display or just the settings section.
Procedure:
•
Enter the pin code.
•
Enter the pin code again.
•
Select restricted Sectionsby checking them.
•
SAVE the settings.
Access protection for the browser menu
In this section, the following parts of the Solar-Log™'s browser menu can be
restricted with a password:
•
User
General access to the
Browser menu
•
Installer
Access to the
Configuration menu
•
Feed-in management
Access to the
Configuration | Feed-in Management menu
The default password for access to the Feed-in Management menu is PM. Access for users and installers is
not restricted.
Note!
We advise installers to discuss with their customers the scope of the settings in the area
of feed-in management, to block the configuration menu using a password and to assign
an individual password.

Solar-Log 2000 Specifications

General

Device Type	Data Logger
Max Inverters	100
Power Supply	24 V DC
Remote Monitoring	Yes
Ethernet interface	Yes
Communication Interfaces	RS485, Ethernet
Protocols	Modbus
Data Storage	Internal