162
Configuration Menu
The current amount of self-consumption is calculated by employing a power meter for self-consumption.
The consumption is calculated with the energy generated by the inverter.
If the difference between the current production and consumption is lower than 70% of the module‘s pow-
er output, the inverters are regulated accordingly, so that the amount of power at the feeding point is still
only at 70% of the connected generator power.
16.12.6 Adjustable reduction
This function allows the maximum amount of grid feed-in power to be configured. The reduction level in
regard to the amount of connected generator power can be freely defined as a percentage (X%). The So-
lar-Log™ only regulates the inverters when the amount of feed-in power for the grid has reached the limit.
Procedure:
•
Select Adjustable reduction.
•
Enter the percentage for the adjustable reduction.
•
Select the inverter(s) to control in the Interface assignments section.
•
SAVE the settings.
16.12.7 Adjustable Reduction with the Calculation of Self-Consumption
This function allows the maximum amount of grid feed-in power to be configured. The reduction le-
vel in regard to the amount of connected generator power can be freely defined as a percentage (X%).
The amount of self-consumption is taken into account for this calculation. The Solar-Log™ only regula-
tes the inverters when the amount of feed-in power for the grid has reached the limit. If there is enough
self-consumption, the inverters continue to operate without any reductions.
Procedure:
•
Select Adjustable reduction with the calculation of self-consumption
•
Enter the percentage for the adjustable reduction.
•
Select the inverter(s) to control in the Interface assignments section.
•
SAVE the settings.
Note!
The Solar-Log™ needs to be linked to a consumption meter to implement this function.
Please note the instructions in chapter “12.5 External power meters“.
To Next Page
Loading...
Need help?
General
