213
Accessing Diagnostic values
To perform a connection test a Wireless Package has to be connected to the Solar-Log™, the interface with
the Wireless Package has to be activated in the
Configuration | Devices | Definition menu and the inver-
ter has to be selected (refer to the RS485 Wireless Package Installation notes).
Select the interface that the Wireless Package is connected to and press the Start button for the connecti-
on test.
The test is successful when the line goes to 100% percent and remains there.
Note!
Successful data transfers can only be guaranteed when the wireless connection is
permanently at 100%.
Note!
Refer to the Installation Manual for the installation and configuration of the Wire-
less Package.
To Next Page
Loading...
