Component Course of action
Load chains
Perform a visual inspection to ensure that the
chains are intact and have adequate and even ten-
sion.
Attachments (variant)
Ensure that the attachments are mounted correctly
in accordance with the operating instructions from
the manufacturer.
Perform a visual inspection to ensure that the at-
tachments are intact and are leak-tight.
Perform checks to ensure the attachments are
working correctly.
Lift cylinders, tilt cylinders, tank, valve
block, hoses, pipes, connections
Perform a visual inspection for damage and leak-
ages.
Have damaged components replaced by the author-
ised service centre.
Underside
Check the area under the truck for leaking consum-
ables.
Wheels, tyres
Perform a visual inspection for wear and damage.
Make sure that only rims of the same type from the
same manufacturer are fitted.
In the event of uneven tyre wear, replace both tyres.
Observe the safety regulations in the section enti-
tled "Tyres".
Axle
Make sure that no consumables are escaping from
the axle.
Check that the temperature sensors and wiring
on the traction motor/pump motor are in good condi-
tion and are securely attached.
The electric cables and line inlets must be free
from damage.
The total damage to the antistatic paintwork and
seat covering must amount to no more than
100 cm
2
.
Overhead guard, guard grille (variant)
Perform a visual inspection for integrity.
Check for secure mounting.
Steps Make sure they are clean (free of ice, not slippery).
Panes of glass (variant)
Perform a visual inspection for integrity.
Make sure they are clean (also free of ice).
Handholds Check for secure mounting.
Maintenance lids Check the close function and close.
Battery hood
Make sure that there are no unused bores in the
battery hood.
Battery door
Perform a visual inspection for integrity and defor-
mation.
Check that the interlock is in good condition and is
working correctly.
Check the close function.
Close.
Operation
4
Checks and tasks before daily use
9556368011531 EN - 01/2021 - 05
To Next Page
Loading...
