Hydraulic system
Code Unit Operating materials Specifications Dimension
System filling Hydraulic oil HVLP 68
DIN 51524, Part 3
23 to 30 l
Dependent on the lift
mast and overall
height
Hydraulic oil for cold
store application
HVLP 32
DIN 51524, Part 3
NOTE
When changing to a different type of hydraulic
oil, the authorised service centre must adjust
the truck control unit.
Tyres
Code Unit Operating materials Specifications Dimension
Superelastic tyres Wear limit To wear mark
Solid rubber tyres Wear limit To wear mark
Pneumatic tyres Minimum tread depth Air pressure: see in-
formation on truck
Min. tread depth: 1.6
mm
Steering axle
Code Unit Operating materials Specifications Dimension
(A)
Axle stub bearing,
spherical bearing
Multi-purpose grease DIN 51825 KPF2 As required
Wheel nuts Torque wrench
Swing axle For further informa-
tion, refer to the
workshop manual for
the truck in question.
Steering axle For further informa-
tion, refer to the
workshop manual for
the truck in question.
Drive axle
Code Unit Operating materials Specifications Dimension
Wheel screws Torque wrench For further informa-
tion, refer to the
workshop manual for
the truck in question.
Wheel gear Gearbox oil SAE 80W-90 API-
GL4
0.3 l
Maintenance
5
General maintenance information
458 56368011531 EN - 01/2021 - 05
To Next Page
Loading...
