EasyManuals Logo

Suzuki SWIFT 2005 User Manual

Suzuki SWIFT 2005
1496 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #887 background imageLoading...
Page #887 background image
Power Assisted Steering System: 6C-5
Terminal Arrangement of P/S Control Module Coupler (Viewed from Harness Side)
Diagnostic Information and Procedures
EPS System Check
S7RS0B6304001
WARNING
!
Carry out test drive in light traffic area to prevent an accident.
Refer to the following items for the details of each step.
Terminal Circuit Terminal Circuit
E49-1
Main power supply for internal memory
and EPS motor
E52-9 Ground for torque sensors
E49-2 Ground for P/S control module E52-10
E51-1 Motor output 1 E52-11
Serial communication for data link
connector
E51-2 Motor output 2 E52-12 Engine speed signal
E52-1
Ignition switch signal for P/S control
module
E52-13
E52-2 E52-14 P/S operation signal (idle up signal)
E52-3 E52-15
E52-4 Vehicle speed signal E52-16 Torque sensor internal failure signal
E52-5 “EPS” warning light E52-17
E52-6 Torque sensor signal (Sub) E52-18 Torque sensor signal (Main)
E52-7 E52-19 Ground for shield wire
E52-8 Main power supply for torque sensor E52-20
5 V reference power supply for torque
sensor
Step Action Yes No
1 ) Customer complaint analysis
1) Perform customer complaint analysis referring to
“Customer Complaint Analysis”.
Was customer complaint analysis performed?
Go to Step 2. Perform customer
complaint analysis.
2 ) DTC check, record and clearance
1) Check for DTC (including pending DTC) referring to
“DTC Check”, Record and Clearance.
Is there any DTC(s)?
Print DTC or write them
down and clear them by
referring to “DTC
Clearance” and go to
Step 3.
Go to Step 4.
3 ) Visual inspection
1) Perform visual inspection referring to “Visual Inspection”.
Is there any faulty condition?
Repair or replace
malfunction part, and go
to Step 11.
Go to Step 5.
4 ) Visual inspection
1) Perform visual inspection referring to “Visual Inspection”.
Is there any faulty condition?
Repair or replace
malfunction part, and go
to Step 11.
Go to Step 8.
5 ) Trouble symptom confirmation
1) Confirm trouble symptom referring to “Trouble Symptom
Confirmation”.
Is trouble symptom identified?
Go to Step 6. Go to Step 7.
6 ) Rechecking and record of DTC
1) Recheck for DTC referring to “DTC Check”.
Is there any DTC(s)?
Go to Step 9. Go to Step 8.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki SWIFT 2005 and is the answer not in the manual?

Suzuki SWIFT 2005 Specifications

General IconGeneral
BrandSuzuki
ModelSWIFT 2005
CategoryAutomobile
LanguageEnglish

Related product manuals