Svantek SVAN 948 - PROFILES Mode of the Measurement Results Presentation

SVAN 948 USER MANUAL
4 - 83
3 PROFILES mode of the measurement results presentation
In 3 PROFILES mode of result’s presentation the selected results from each channel are displayed
in three consecutive lines. In each line the name of the measurement result, its value and the units are
presented. The channels are separated by two straight horizontal lines. These lines are doted in other
modes than vibration level meter. In the case of HAV or WBV measurements 3 PROFILES mode is
similar as in VLM mode, except of the VEC position which appears in this model.
The view of the displays in 3 PROFILES presentation – the changing of the channels
On the display there are show three lines. User is able to rewind view by pressing the <SHIFT> with
<

> or <SHIFT> with <

> push-buttons. The change of the active channel (this in which the name is
displayed inversely) is performed by means of the <SHIFT> with <

> or <SHIFT> with <

> push-
buttons. The switching between the simultaneously calculated results is performed by means of the <

>,
<

> push-buttons.