SVAN 948 USER MANUAL
5 - 31
changes made in the sub-list are confirmed and the sub-list is closed. The return to the SETUP sub-list
ignoring any changes made in the sub-list after pressing the <ESC> push-button.
The view of the displays in the VECTRO DEF. (path: MENU / SETUP / VECTOR DEF.)position;
the selection of the parameters
Notice: It is possible to change the values during the measurements
If the user selects wrong k-coefficient, it appears on the display the text: INCORRECT SETUP,
VIB. DOSE IS OFF and measurements of dose will not be done. Otherwise the measurement will be
continued. The selected coefficient should be consistent with the number of selected channel in AXIS
SETUP (path: MENU / SETUP / HAV/WBV DOSE / AXIS SETUP).
The view of the displays informed about wrong selected settings
Selection of the vibration dose - HAV/WBV DOSE
The HAV/WBV DOSE position (path: MENU / SETUP / HAV/WBV DOSE) is used to determine the
vibration dose. In order to enter this sub-list the user has to select the HAV/WBV DOSE text in the
SETUP list, using the <
>, <
> (or <
>, <
>) push-buttons and press the <ENTER>. The selection of
a parameter which level has to be set is done by means of the <
>, <
> push-buttons.
The view of the display in the SETUP list in the HAV/WBV DOSE text highlighted (displayed inversely)
The selection of a parameter which level has to be set is done by means of the <
>, <
> push-
buttons.
The view of the displays with the HAV/WBV DOSE list
To Next Page
Loading...