Svantek SVAN 948 - Removing a File with the Measurement Results from Memory - DELETE

SVAN 948 USER MANUAL
5 - 45
The view of the display during the execution of the LOAD operation
The next message is displayed after successful end of loading operation. The instrument waits for
the reaction of the user (any push-button should be pressed except the <SHIFT> one) and after pressing
a push-button it returns to the FILE list.
The view of the displays after the execution of the LOAD operation
Removing a file with the measurement results from memory - DELETE
The DELETE (path: MENU / FILE / DELETE) is used to remove a file from memory. After pressing
the <ENTER> push-button the instrument checks its current state. In the case when the measurements
are performed, the DELETE position entering is impossible. In such case the message with the changing
letters is displayed (see below) and the instrument returns after few seconds to the list from which the
DELETE was called.
The view of the displays with the message stating the reason for unfeasibility of the required operation
In the case when the instrument memory is empty (no file is stored), after entering the DELETE
position the NO FILES text is displayed and the instrument waits for the reaction of the user. The user
should press then the <ESC>, <ENTER> or <START / STOP> push-button.
The view of the displays in the FILE sub-list with the DELETE text highlighted (displayed inversely)
The same data about the existing in the instrument files as in the LOAD position are displayed on
the display after successful opening the DELETE position (pressing the <ENTER> push-button). In the
consecutive lines of the display the current file number, the total number of the files, the file name, the file
type, date and time of registration are presented. The change of the current file with the unit step can be