Svantek SVAN 948 - Selection of the RMS Detector in SLM - DETECTOR; Selection of the RMS Detector in VLM - DETECTOR

SVAN 948 USER MANUAL
4 - 29
The view of the displays in the PROFILE 2 sub-list; the selection of the weighting filter in the case of velocity
measurements
• in the case of the displacement measurements: Dil1, Dil3 and Dil10.
The view of the displays in the PROFILE 2 sub-list; the selection of the weighting filter in the case of
displacement measurements
The characteristics of the filters are given in Appendix D. The selection of the required filter is made
with the <

>, <

> push-buttons. The user can pass to the selection of the next parameter from the
CHANNEL x sub-list pressing the <

>, <

> push-buttons. After pressing the <ENTER> push-button any
changes made in the sub-list are confirmed and the sub-list is closed. The return to the
CHANNELS SETUP sub-list ignoring any changes made in the sub-list is made after pressing the <ESC>
push-button.
Selection of the RMS detector in SLM - DETECTOR
In the instrument’s SLM mode three RMS detectors are available: IMPULSE, FAST and SLOW.
The selection of the required detector is made with the <

>, <

> push-buttons. The user can pass to the
selection of the next parameter from the CHANNEL x sub-list pressing the <

>, <

> push-buttons. After
pressing the <ENTER> push-button any changes made in the sub-list are confirmed and the sub-list is
closed. The return to the CHANNEL SETUP sub-list ignoring any changes made in the sub-list is made
after pressing the <ESC> push-button.
The view of the displays in the CHANNEL 3 sub-list; the selection of the detector time constant
Selection of the RMS detector in VLM - DETECTOR
In the instrument’s VLM mode the selection of the required detector is made with the <

>, <

>
push-buttons. The following detectors are available: 100 ms, 125 ms, 200 ms, 500 ms, 1.0 s, 2.0 s, 5.0 s