SVAN 948 USER MANUAL _
5 - 44
Notice: It is not possible to load the file during the execution of the measurements. On
such attempt the message: „measurement in progress / MEASUREMENT IN PROGRESS” is displayed
for about 2 seconds.
After pressing the <ENTER> push-button the instrument checks its current state. In the case when
the measurements are performed the file loading is impossible. In such case the message with the
changing letters is displayed (see below) and the instrument returns after few seconds to the list from
which the LOAD position was called.
The view of the displays with the message stating the reason for unfeasibility of the required operation
In the case when the instrument memory is empty (no file is stored), after entering the LOAD
position the NO FILES text is displayed and the instrument waits for the reaction of the user. The user
should press then the <ESC>, <ENTER> or <START / STOP> push-button.
The view of the displays during the execution of the LOAD operation
The current number of the file and the total number of the saved files is displayed in the first line.
The name of the file is displayed inversely in the second line (its current number is presented in the first
line). If the file contains the results from the buffer, the number of the buffer is displayed at the right end of
this line. The type of the current file (LEVEL METER, 1/1 OCTAVE, 1/3 OCTAVE etc.) and measure
mode in each of four channels (SOUND or VIBRATION) are given in the third line. Date and time of the
SAVE operation is displayed in the fourth line. The change of the current file with the unit step can be
done after pressing the <
>, <
> push-buttons. After pressing the <
> with <SHIFT> push-button the
first file is available and after pressing the <
> with <SHIFT> push-button - the last one is displayed.
The view of the displays during the overview of the file list
The name of the file is accepted and the file is loaded after pressing the <ENTER> push-button.
The message is displayed with the name of the selected file during the execution of the operation i.e.:
To Next Page
Loading...