SVAN 948 USER MANUAL _
5 - 20
• VIEW
o VIEW enables the user to select which filter should be viewed; the available options are
VUSR1, VUSR2, VUSR3 and any other transmitted to the instrument from a PC by means of
the interface
After pressing the <ENTER> push-button another sub-list opens containing the values of filters
used in 1/1 OCTAVE or 1/3 OCTAVE analysis and saved under the name VUSR1, VUSR2,
VUSR3 or any other
• EDIT
o EDIT- enables the user to select which filters should be edited; the available options are as
follows: VUSR1, VUSR2, VUSR3 or any other transmitted t o the instrument from a PC by
means of the interface
After pressing the <ENTER> push-button another sub-list opens containing the values of the
filters used in 1/1 OCTAVE or 1/3 OCTAVE analysis; the user can set the values of correcting
coefficients for all 1/3 OCTAVE filters:
v 0.80 Hz: available values of 0.8 Hz centre frequency filter: -100.0dB ... 100.0dB
v 1.00 Hz: available values of 1Hz centre frequency filter: -100.0dB ... 100.0dB
v
v ...
v …
v 20.0kHz: available values of 20 kHz centre frequency filter: -100.0dB ... 100.0dB
• CLEAR (position)
• CLEAR enables the user to select which filters should be cleared; the available options are as
follows: ALL, VUSR1, VUSR2, VUSR3 or any other
SOUND FILTERS
• VIEW
o VIEW enables the user to select which filter should be viewed; the available options are
SUSR1, SUSR2, SUSR3 and any other transmitted to the instrument from a PC by means of
the interface
After pressing the <ENTER> push-button another sub-list opens containing the values of filters
used in 1/1 OCTAVE or 1/3 OCTAVE analysis and saved under the name SUSR1, SUSR2,
SUSR3 or any other
• EDIT
o EDIT- enables the user to select which filters should be edited; the available options are as
follows: SUSR1, SUSR2, SUSR3 or any other transmitted t o the instrument from a PC by
means of the interface
After pressing the <ENTER> push-button another sub-list opens containing the values of the
filters used in 1/1 OCTAVE or 1/3 OCTAVE analysis; the user can set the values of correcting
coefficients for all 1/3 OCTAVE filters:
v 0.80 Hz: available values of 0.8 Hz centre frequency filter: -100.0dB ... 100.0dB
v 1.00 Hz: available values of 1Hz centre frequency filter: -100.0dB ... 100.0dB
v
v ...
v …
v 20.0kHz: available values of 20 kHz centre frequency filter: -100.0dB ... 100.0dB
• CLEAR (position)
• CLEAR enables the user to select which filters should be cleared; the available options are as
follows: ALL, SUSR1, SUSR2, SUSR3 or any other
The selection of the position in this sub-list is performed by means of the <
>, <
> (or <
>,
<
>) push-buttons. The sub-list is closed and the instrument returns to the SETUP list after pressing the
To Next Page
Loading...