TeeJet Matrix Pro 570GS - Multiple Sections

45
98-05273-EN R7
MATRIX
®
Pro 570GS
•
MATRIX
®
Pro840GS
HOMESETUPGUIDANCE FULL SCREEN INTRODUCTIONGNSSRATE CONTROLAPPENDIX IMPLEMENT
Figure 6-9: Single section
Figure 6-10: Distances and length
Figure 6-11: Lateral Offset Direction and Distance
Multiple sections
Section control is available (SmartCable, Section driver module
(SDM), or Switch function module (SFM).
1. Select Spreader implement type on Implement screen.
2. Press Implement type NEXT PAGE arrow .
3. Select from:
►Setup type – used to select
TeeJet spreader type
►Antenna to Disks distance
 – used to dene the
distance from the GNSS antenna to the disks or dispersal
mechanism
►Implement Lateral offset direction
 – denes the lateral
direction, either left or right, from the centerline of the
machine to the center of the implement while facing in the
machine's forward direction
►Implement lateral offset distance
 – denes the lateral
distance from the centerline of the machine to the center of
the implement in decimal meters
►Overlap – used to dene the amount of overlap allowed
when using automatic boom section control
►Delay on time – used to set the time when the section will
switch on when entering an area that has not been applied
NOTE: If the application turns on too soon when entering
an unapplied area, decrease the Delay on time. If the
application turns on too late, increase the Delay on time.
►Delay off time – used to set the time when the section will
switch off when entering an area that has been applied
NOTE: If the application turns off too soon when entering
an unapplied area, decrease the Delay off time. If the
application turns off too late, increase the Delay off time.
►Spread offset distance  – used to set the distance
between the disks or dispersal mechanism and where
product initially hits the ground on Section 1.
►Section offsets  – used to set the offset distance from
Section 1 (the Spread Offset line) to the leading edge of
each section. Section 1 is always 0. All other sections can
be different distances.
►Section lengths
 – used to set the length of application in
each section. Each section can be a different length.
NOTE: Sections are numbered from left to right while
facing in the machine's forward direction.
4. Press RETURN arrow
to return to the Implement screen
or CONFIGURATION side tab to return to the main
Conguration screen.