Need help?Do you have a question about the TeeJet Matrix Pro 570GS and is the answer not in the manual?
Steps to configure GNSS receiver and view status.
Setup for implements and assisted/auto steering systems.
Details of console hardware and features for both models.
Correcting GNSS signal for hilly terrain using SCM or Tilt gyro module.
Details on configuring implements, mapping, GNSS, video, sensors, product, and auto-steer.
Transferring, managing, and importing/exporting job information.
Settings for implement types, sections, width, droplet size, and nozzle selection.
Configuration of mapping location, guidance width, and lightbar settings.
Selecting between Simple or Advanced job modes.
Setup and calibration for assisted/auto steering and tilt correction.
Selecting the application pattern type: Straight, Spreader, or Staggered.
Setup for single or multi-section implements with or without section control.
Configuration for mapping location, guidance width, and console/lightbar settings.
Setup for cameras and video selection modules.
Configuration of pressure sensor interface kits.
Enabling, disabling, and calibrating assisted/auto steering systems.
Setup for FieldPilot and UniPilot Pro systems, managing vehicle and calibration.
Uploading software updates for system devices from a USB drive.
Setup for GNSS type, port, PRN, and status information.
Displaying current GNSS status, including data rates, satellites, and quality.
Selecting the application pattern type: Straight, Spreader, or Staggered.
Setup for straight implements, defining in-line and lateral offsets.
Setup for implements with section control, defining offsets, overlap, and delays.
Entering application or working width for single or multiple sections.
Setup for TeeJet spreaders, defining distances, offsets, and section lengths.
Steps to configure GNSS receiver and view status.
Setup for implements and assisted/auto steering systems.
Details of console hardware and features for both models.
Correcting GNSS signal for hilly terrain using SCM or Tilt gyro module.
Details on configuring implements, mapping, GNSS, video, sensors, product, and auto-steer.
Transferring, managing, and importing/exporting job information.
Settings for implement types, sections, width, droplet size, and nozzle selection.
Configuration of mapping location, guidance width, and lightbar settings.
Selecting between Simple or Advanced job modes.
Setup and calibration for assisted/auto steering and tilt correction.
Selecting the application pattern type: Straight, Spreader, or Staggered.
Setup for single or multi-section implements with or without section control.
Configuration for mapping location, guidance width, and console/lightbar settings.
Setup for cameras and video selection modules.
Configuration of pressure sensor interface kits.
Enabling, disabling, and calibrating assisted/auto steering systems.
Setup for FieldPilot and UniPilot Pro systems, managing vehicle and calibration.
Uploading software updates for system devices from a USB drive.
Setup for GNSS type, port, PRN, and status information.
Displaying current GNSS status, including data rates, satellites, and quality.
Selecting the application pattern type: Straight, Spreader, or Staggered.
Setup for straight implements, defining in-line and lateral offsets.
Setup for implements with section control, defining offsets, overlap, and delays.
Entering application or working width for single or multiple sections.
Setup for TeeJet spreaders, defining distances, offsets, and section lengths.
General| Display Type | Color LCD |
|---|---|
| Touchscreen | Yes |
| Resolution | 640 x 480 pixels |
| Mapping | Yes |
| Data Logging | Yes |
| Power Supply | 12V DC |
| Operating Temperature | -20°C to 60°C |
| Waterproof Rating | IP67 |
| Weight | 1.2 kg |
| GPS Receiver | Integrated |
| Connectivity | USB, Bluetooth |
| Display Size | 5.7 inches |
To Next Page
