Tektronix MSO 2 Series - Page 269

how to (continued)
Add reference waveform 62
add waveform to screen 61
change display settings 73
change graticule intensity 73
change graticule style 73
change measurement settings 66
change persistence 73
change waveform colors 192
change waveform intensity 73
change waveform interpolation 73
check power-on self tests results 18
configure a results table 120
connect probes 26
connect to network 52
connect to PC using USB cable 54
delete a measurement 67
delete columns in a results table 120
delete individual measurements from a results table 120
display cursors 74
download, install firmware 49
enable daylight saving time mode 166
load a reference waveform 103
load a Session file. 104
move columns in a results table 120
open acquisition menu 60
open horizontal menu 58
quickly display waveform (Autoset) 57
recall a reference waveform 103
recall a Session file. 104
recall an instrument setup 103
run signal path compensation (SPC) 50
save a plot image to a file 207
save a report to a file 101
save a screen image 100
save a session 102
save a spectrum trace file 100
save a waveform file 100
save instrument settings 101
save plot data to a file 207
search on an event 72
set acquisition parameters 60
set channel vertical parameters 62
set clock format (12/24 hr) 49
set custom waveform colors 192
set fall time trigger 83
set GPIB talk/listen address 54
set horizontal parameters 58
set logic trigger 82
set probe deskew 62
set probe parameters 62
set pulse width trigger 79
set rise time trigger 83
set setup/hold trigger 83
set time zone 49, 166
set timeout trigger 80, 81
set trigger holdoff 85
set trigger parameters 59
use Autoset 57
use mouse with the UI 46
How to
change display mode (stacked, Overlay) 73
how to compensate probes 51
I
I/O 193
I2C bus trigger settings 220
I2C serial bus menu 129
idata, plot 207
image, plot 207
Impulse-response testing 255
inactive channel buttons 35
ink saver mode 182, 188
Input
resistance 235
termination
235
Input channel
trigger sources 237
input signal level requirements 18
install license 201
install option license
how to 18, 26, 46, 49, 50, 52, 54, 57–62, 64, 66, 67, 72–74, 76,
79–83, 85, 100–104, 116, 120–123, 166, 192, 202, 203, 207
installed options 201
installed probes 201
instrument settings
saving 101
instrument setup
recalling 103
instrument with battery pack stand 25
intensity, graticule 73
intensity, waveform 73
interpolation 87, 235
Interpolation 234
Interpolation mode, setting 231
Invert channel guidelines 162
inverted screen color mode 188
IP address 193
J
jitter separation model 188
K
Kaiser-Bessel FFT window
defined 254
keyboard 230
keyboard, installing
56
keypad 231
L
label, measurement 116
LAN 193
LAN reset 193
LAN Reset 195
2 Series MSO MSO24 and MSO22 269