Terason t3000 - Chapter 2: Installing Software; Installing Terason Software

Terason t3000 / Echo Ultrasound System User Guide 37
2 Installing Software
When you purchase the Terason Ultrasound System, it comes with all the required
software already installed on the laptop. You may never need the information in this
chapter unless you upgrade your system, or if you want to install the Terason Ultrasound
System on a computer that was not provided by Terason.
If you must install, uninstall, or configure part of the Terason Ultrasound System,
instructions for the following operations are included in this chapter:
• Installing Terason Software on page 37
• Upgrading Terason Software on page 39
• Uninstalling Terason Software on page 41
• Installing the FireWire Terason Transducer Driver on page 42
• Installing the Terason DICOM Utility on page 44
• Licensing the Terason Software on page 50
For information on connecting hardware components, or if you must reinstall the
computer’s operating system, refer to the Configuration Guide that came with your
system.
Installing Terason Software
Terason Ultrasound System are shipped with all required software installed on the laptop.
You do not need to complete the following procedure unless you want to install the
Terason Ultrasound System on a computer that was not provided by Terason.
When ready, complete these steps:
1. Exit all applications including email, and unplug the Terason engine from the laptop
if it has already been installed.
2. Insert the Terason CD into the CD-RW drive. An InstallShield message displays as it
prepares to install the software, then the Welcome dialog box opens.
3. Click
Next>. The License Agreement dialog box appears. Read the License
Information carefully.
4. Click
Yes. The Choose Destination Location dialog box opens.