iCNC Performance
Manual 0-5401 iCNC SETUP 7-1
SECTION 7: iCNC SETUP
1. Motion
2. I/O
3. Cutting table data
5. Others
6. Backups
7. Rotating axis
8. HD Unlocked/Locked
Enter Administrator Mode
Password prompt
1.1. Drive conguration
1.2. Drive and encoder polarities
1.3. Encoder values
1.4. Drift adjustment (only analog speed)
1.5. Max speed adjustment
1.6. Max speed test (only analog speed)
1.7. Min speed test (only analog speed)
1.8. Motion parameters
2.1. General
2.2. IO and Delay
2.3. Outbits
2.4. Inbits
3.1. Homing / limits
3.2. Downdraft
5.1. General
5.2. THC / Plasma settings
5.3. Teach In
5.4 Get serial number
5.6 Diagnostic information
5.7 Advanced diagnostics
5.9 Calibrate touch screen
6.1. Backup machine settings
6.2. Restore machine settings
7.1. Tangential Rotation (future use)
8.1. Change Status
7.1 Initial Checks
Before starting to adjust the settings make sure that:
- All cables are properly connected
- General IO settings are correct (limits, e-stop...) so that you do not have any error messages on the screen, see 7.5.1
- Motors are out of rails
CAUTION
Some settings may cause abrupt machine motion. Take care of your surroundings and make sure the motors can run free.
To Next Page
Loading...
Need help?
General