Thermal Dynamics iCNC Performance - 7.5.2.3 I;O and Delay Gas Cutting

To Next Page

To Previous Page

iCNC Performance

7-20 iCNC SETUP Manual 0-5401

7.5.2.3 I/O and Delay Gas Cutting

Here you can map the I/O’s and set the delay times for oxy fuel cutting. You have 4 pre set parameter sets and a custom to

create your own.

Set 1 is used when only preheat, cut oxygen and vent signals are used.

Set 2 is used when capacitive height sensing, preheat, cut oxygen, vent and torch up/down while piercing signals are used.

Set 3 is used when ignition, capacitive height sensing, preheat, cut oxygen, vent and torch up/down while piercing signals

are used.

Set 4 is reserved for future use.