Tonghui TH2840 Series - Page 178

170
Example:
:TRT:BIAS:CURR1 1m ----Set the bias current of the first point;
:TRT:BIAS:CURR6 5m ----Set the bias current of the sixth point;
:TRT:BIAS:CURR4? ----Return to the bias current of point 4
9.2.19.8 Turn ratio relative reference value
 Description: Set the relative reference value under the turn ratio function
Command systax:
:TRT:TURN<n>?
:TRT:TURN<n><fn>
Parameter:
n ---- Specify the index of the sweep point, ranging from 1 to 12
fn ---- The floating-point number of sweep point n
Example:
:TRT:TURN1 1 ----Set the relative reference value of the first point under turn ratio function to 1
turn;
:TRT:TURN610 ----Set the relative reference value of the 6th point under turn ratio function to 10
turns;
:TRT:TURN4? ----Return to the relative reference value of the 4th point under turn ratio function.
9.2.19.9 Deviation and nominal value
 Description: Set the deviation comparison mode of the instrument
Command systax:
:TRT:DEV<n>?
:TRT:DEV<n><ABS|PER|OFF>
Parameter:
ABS----ΔAbsolute deviation
PER ----Δ% percent deviation
OFF ---- OFF
Example:
:TRT:DEV1 ABS ----Set the comparison mode of point 1 to absolute deviation
:TRT:DEV2 PER ----Set the comparison mode of point 2 to percent deviation
:TRT:DEV3 OFF ----Turn off the deviation mode of comparison mode of point 3
:TRT:DEV2? ----Return to the deviation mode of comparison mode of point 2
 Description: Set the nominal value of the deviation of the instrument
Command systax:
:TRT:NOM<n>?
:TRT:NOM<n><float>
Parameter:
float ---- Represent the floating-point number
Example: