Tonghui TH2840 Series - Handler Subsystem Commands

157
Example:
:TSSE:IMP CP,CS,LP,LS ----Set 4 parameter functions at the same time
:TSSE:IMP1 RP ----Set parameter 1 to RP
:TSSE:IMP2 RS ----Set parameter 1 to RS
:TSSE:IMP3 Z ----Set parameter 1 to Z
:TSSE:IMP4 Y ----Set parameter 1 to Y
:TSSE:IMP1? ----Query parameter 1 function
:TSSE:IMP2? ----Query parameter 2 function
:TSSE:IMP3? ----Query parameter 3 function
:TSSE:IMP4? ----Query parameter 4 function
:TSSE:IMP? ---- Query the 4-parameter function
9.2.15 Handler subsystem commands
9.2.15.1 LCR handler subsystem commands
 Description: Set LCR Handler mode
Command systax:
:HAND:STAT?
:HAND:STAT <0|1|2|OFF|ON|BUS>
Parameter:
0|OFF ---- means default
1|ON ---- means custom
2|BUS ---- means bus control
Example:
:HAND:STAT 0 ----Set the HANDLE mode as default;
:HAND:STAT OFF ----Set the HANDLE mode as default;
:HAND:STAT 1 ----Set the HANDLE mode to custom;
:HAND:STAT ON ----Set the HANDLE mode to custom;
:HAND:STAT BUS ---- Return to the HANDLE mode to BUS.
 Description: Set LCR Handler custom output control
Command systax:
:HAND:STAT:OFfLO <…>
:HAND:STAT:OFfHI <…>
:HAND:STAT:LVLO <…>
:HAND:STAT:LVHI <…>
:HAND:STAT:PUHI <…>
:HAND:STAT:PULO <…>
Parameter:
<…> is a list format, such as 1, 2, 4, 7, 14, 24, etc., corresponding to the table position displayed by
the instrument
Example:
:HAND:STAT:OFLO 1,3,5,9 ----Set the 1,3,5,9 index function as constant low level;