Tonghui TH2840 Series - TRACE Subsystem Commands

154
f
n
---- The floating point number of the sweep point n
f
n+1
---- The floating point number of the sweep point n+1
f
n+2
---- The floating point number of the sweep point n+2
f... ---- The floating point number of the sweep point n…
Example:
:LIST:DEL 0.01, 20m, 30m ---- Set the test delay of the first 3 points;
:LIST:DEL 1m, 2m, 3m, 4m, 2m ---- Set the test delay of the first 5 points;
:LIST:DEL6 1m, 2m, 3m, 4m, 5m ---- Set the test delay of 6~10 points;
:LIST:DEL25 20m ---- Set the test delay of the 25th point;
:LIST:DEL? ----Return to the test delay of all sweep points;
:LIST:DEL4? ----Return to the test delay of point 4.
9.2.14 TRACE subsystem commands
9.2.14.1 Sweep Points
 Description: Set the number of LCR curve scan points
Command systax:
:TSSE:POINT?
:TSSE:POINT <51|101|201|401|801>
Parameter:
51 ---- means scanning 51 points
101 ---- means scanning 101 points
201 ---- means scanning 201 points
401 ---- means scanning 401 points
801 ---- means scanning 801 points
Example:
:TSSE:POINT 51 ----Set LCR to scan 51 points
:TSSE:POINT 101 ----Set LCR to scan 101 points
:TSSE:POINT 201 ----Set LCR to scan 201 points
:TSSE:POINT 401 ----Set LCR to scan 401 points
:TSSE:POINT 801 ----Set LCR to scan 801 points
:TSSE:POINT? ----Query the LCR sweep points
9.2.14.2 Sweep Type
 Description: Set the sweep parameter type of LCR curve
Command systax:
:TSSE:MODE?
:TSSE:MODE <FREQ|VOLT|CURR|BVOL|BCUR>
Parameter:
Enumeration type string parameter;
Example: