Tonghui TH2840 Series - Fetch? Subsystem Commands

158
:HAND:STAT:OFHI 1,3,5,9 ----Set the index function of 1,3,5,9 to a constant high level;
:HAND:STAT:LVLO 1,3,5,9 ----Set the index function of 1,3,5,9 to active low level;
:HAND:STAT:LVHI 1,3,5,9 ----Set the index function of 1,3,5,9 to active high level;
:HAND:STAT:PUHI 1,3,5,9 ----Set the index function of 1,3,5,9 to active high pulse;
:HAND:STAT:PULO 1,3,5,9 ----Set the index function of 1,3,5,9 to active low pulse;
 Description: Set LCR Handler bus output control
Command systax:
:HAND:OUTP:LVHI <…>
:HAND:OUTP:LVLO <…>
Parameter:
<…> is a list format, such as 1, 2, 4, 7, 14, 24, etc., corresponding to the table position displayed by
the instrument
Example:
:HAND:LVHI:LVHI 1,3,5,9 ----Set 1,3,5,9 to output high level in bus mode;
:HAND:LVLO:LVLO 1,3,5,9 ----Set 1,3,5,9 to output low level in bus mode;
9.2.16 FETCh? subsystem commands
9.2.16.1 General query test results
 Description: Query the result of the last measurement in the current test mode
Command systax:
:FETCh? ----Returns the test result of the parameter
Parameter:
Example:
Test page
LCR
Meter
Component
testing
Parameter 1 Result, Parameter 2 Result, Parameter 3 Result, Parameter 4
Result, the sorting results:
such as: 1.12345E2, 1.23456E-2, 1.11023E2, -1.12345E2,1
The sorting results take the following values:
Note: The <bin> data will only be displayed when the instrument compare
function is turned ON.
Sorting result
Description
0
BIN OUT
1~10
BIN 1~10
List sweep
Return to the test result of the current test point.
Clike index, parameter 1 result, parameter 2 result, parameter 3 result,
parameter 4 result, the compare results:
such as: 2,1.12345E2,1.23456E-2,1.11023E2,-1.12345E2,1
The comparison results are as follows:
Compare
results
Description