Tonghui TH2840 Series - ACR Test Conditions Setup

96
7.11.7 ACR Test Conditions Setup
On the <Trans Condition> page of the transformer scan, touch or move the cursor to a column of
ACR in the test condition table to set the ACR parameters.
7.11.7.1 ACR Limit Setup
The ACR limit setting table is used to set the standard value, upper and lower limit, multi-frequency
and multi-level of ACR.
Touch the ACR limit setting table, or move the cursor to the ACR limit setting area, and use the
numeric keys, corresponding magnification or [ENTER] key to set.
The magnification corresponding to ACR is M, k, μ, m, and the [ENTER] key is x1.