Tonghui TH2840 Series - System System Subsystem Commands

172
9.2.19.12 Delay
 Description: Set the sweep point test delay
Command systax:
:TRT:DEL[n]?
:TRT:DEL[n] <fn>
Parameter:
n ---- Specify the index of the sweep point, ranging from 1 to 12
fn ---- the floating-point number of sweep point
Example:
:TRT:DEL1 0.01 ----Set the test delay of point 1;
:TRT:DEL2 3m ---- Set the test delay of point 2;
:TRT:DEL6 5m ----Set the test delay of point 3;
:TRT:DEL4? ----Return to the test delay of point 4;
9.2.19.13 Switch
 Description: Set the sweep point switch state
Command systax:
:TRT:STAT[n]?
:TRT:STAT[n] <OFF|0|ON|1>
Parameter:
n ---- Specify the index of the sweep point, ranging from 1 to 12
OFF|0 ---- Turn off the test function of the point
ON|1 ---- Turn on the test function of the point
Example:
:TRT:STAT1 OFF ----Turn off the test function of point 1
:TRT:STAT2 0 ----Turn on the test function of point 2
:TRT:STAT3 ON ----Turn on the test function of point 3
:TRT:STAT8 1 ----Turn on the test function of point 8
:TRT:STAT12? ----Return to the test function switch of point 12.
9.2.20 SYSTem system subsystem commands
The SYSTem subsystem command set is mainly used to set system-related parameter functions.
9.2.20.1 Bus Mode
 Description: Set the command mode of the communication interface
Command systax:
:SYST:BUSMODE?
:SYST:BUSMODE <RS232|LAN|USBTMC|USBCDC|AUTO>
Parameter: