AUTO ----Automatically select the communication interface
Others ---- lock the communication interface to the command communication interface
Example:
:SYST:BUSMODE? ----Query the current communication interface mode
:SYST:BUSMODE RS232 ----Set the bus communication as a fixed RS232 interface
:SYST:BUSMODE LAN ----Set the bus communication as a fixed LAN interface
:SYST:BUSMODE USBTMC ----Set the bus communication as the fixed USBTMC interface
:SYST:BUSMODE USBCDC ----Set the bus communication as the fixed USBCDC interface
:SYST:BUSMODE AUTO ----Set the bus communication to the automatic interface mode
9.2.20.2 Key Sound
Description: Set the key sound mode
Command systax:
:SYST:BEEP?
:SYST:BEEP <OFF|ON|0|1>
Parameter:
0|OFF ---- OFF
1|ON ---- ON
Example:
:SYST:BEEP? ----Query the current key sound setup
:SYST:BEEP 0 ----Set the key sound to off
:SYST:BEEP OFF ----Set the key sound to off
:SYST:BEEP 1 ----Set the key sound to on
:SYST:BEEP ON ----Set the key sound to on
Description: Set the beeper mode for PASS sorting
Command systax:
:SYST:BEEP:PASS?
:SYST:BEEP:PASS <OFF|TwoShort|LowLong|HighShort|HighLong>
Parameter:
OFF ---- off
Others correspond respectively: two short, low long, high short, high long
Example:
:SYST:BEEP:PASS? ----Query the current PASS beeper setting
:SYST:BEEP:PASS OFF ----Set the PASS beeper mode to OFF
:SYST:BEEP:PASS TS ----Set the PASS beeper mode to two short
:SYST:BEEP:PASS LL ----Set the PASS beeper mode to low long
:SYST:BEEP:PASS HS ----Set the PASS beeper mode to high short
:SYST:BEEP:PASS HL ----Set the PASS beeper mode to high long
Description: Set the beeper mode for FAIL sorting
Command systax:
:SYST:BEEP:FAIL?
To Next Page
Loading...
