4.1.5 Tools
4.1.5.1 Preset
For the convenience of customers, the instrument can be initialized to a known unified initial state.
Standardize initial software operation design .
In order to solve the problem of inconsistent setting status when the instrument leaves the factory.
Restore the following parameters to the factory
default settings:
a. Parameters set through front panel operation
b. Parameters set by SCPI commands
Restore the following parameters to the factory
default settings:
a. Parameters set through front panel operation
b. Parameters set by SCPI commands
c. Power-off protection parameters
d. Clear user correction data
Restore the following parameters to the factory
default settings:
a. Parameters set through front panel operation
b. Parameters set by SCPI commands
c. Power-down protection data
d. Clear user reset data
e. Clear files saved by users
Note: Parameters that cannot be initialized
The initialization operation is not allowed to clear the system calibration data.
The real-time clock date and time are not allowed to be cleared or initialized.
Please refer to the appendix for the detailed recovery list of parameters later.
4.1.5.2 Update
This function is mainly used for software version upgrade and maintenance. This series of machines
is designed with multiple CPUs. For user convenience, one-key upgrade operation is provided. After
the one-key upgrade operation, the user only needs to wait for about 2 minutes according to the
prompts. After the upgrade is completed, the instrument will automatically restart. After restarting,
you can return to this menu to see whether the software version is the latest version after the
upgrade.
The menu display is shown in Figure 4-1-2:
To Next Page
Loading...
