Tonghui TH2840 Series - TRAN Subsystem Commands

167
mode
of internal files
Example:
:MMEM:STOR 1 ----Save LCR.sta file (in LCR mode)
:MMEM:STOR 9 ----Save LCR9.sta file (in LCR mode)
:MMEM:STOR5,sss.sta ----Save the file with the path sss.sta
:MMEM:STOR5,files/sss.sta ----Save the file whose path is files/sss.sta
:MMEM:STOR5,usb/sss.sta ----Save the file whose path is usb/sss.sta
9.2.19 TRAN subsystem commands
The TRAN subsystem commands are mainly used to transformer parameters, such as turn-ratio,
primary inductance, leakage inductance, stray capacitance, impedance, AC impedance, DC
resistance, working mode and limits of each parameter.
9.2.19.1 Test mode
 Description: Set single group test mode
Command systax:
:TRT:MODE?
:TRT:MODE<SEQ | STEP>
parameter:
SEQ ---- Continue
STEP ----Single STEP
Example:
:TRT:MODE SEQ ----Set to continue mode
:TRT:MODE STEP ----Set to single step mode
:TRT:MODE? ----Return to single group test mode
9.2.19.2 Compare
 Description: Set single group compare mode
Command systax:
:TRT:COMP?
:TRT:COMP <OFF|0|ON|1>
Parameter:
OFF|0 ---- Turn off the compare function
ON|1 ----Turn on the compare function
Example:
:TRT:COMP OFF ---- Turn off the compare function
:TRT:COMP 0 ---- The same as above
:TRT:COMP ON ----Turn on the compare function
:TRT:COMP 1 ---- The same as above
:TRT:COMP? ----Return to single group compare function switch