Tonghui TH2840 Series - Mass Memory Subsystem Commands

165
:CORR:SPOT10:OPEN ---- Perform open circuit correction on frequency point 10
Returns 1 for open circuit success and 0 for failure
 Description: Perform short-circuit correction for instrument specific frequency points
(Frequency 1, Frequency 2...)
Command systax:
:CORR:SPOT<n>:SHOR
Parameter:
Example:
:CORR:SPOT1:SHOR ---- Perform short-circuit correction on frequency point 1
:CORR:SPOT2:SHOR ---- Perform short-circuit correction on frequency point 2
:CORR:SPOT10:SHOR ---- Perform short-circuit correction on frequency point 10
Returns 1 for open circuit success and 0 for failure
 Description: Perform load correction reference values for specific frequency points of the
instrument (Frequency 1, Frequency 2...)
Command systax:
:CORR:SPOT<n>:LOAD:STAN?
:CORR:SPOT<n>:LOAD:STAN <refA,refB>
Parameter:
refA ---- the floating point data of reference A
refB ---- the floating point data of reference B
Example:
:CORR:SPOT1:LOAD:STAN 1.1,1.2 ---- The reference value for load correction at frequency point
1
:CORR:SPOT2:LOAD:STAN 1.1,1.2 ---- The reference value for load correction at frequency point
2
:CORR:SPOT10:LOAD:STAN? ----Return to the reference value for load correction of frequency
point 10
 Description: Perform load correction on instrument specific frequency points (Frequency 1,
Frequency 2...)
Command systax:
:CORR:SPOT<n>:LOAD
Parameter:
Example:
:CORR:SPOT1:LOAD ---- Perform load correction of frequency point 1
:CORR:SPOT2:LOAD ---- Perform load correction of frequency point 2
:CORR:SPOT10:LOAD ----Return to perform load correction of frequency point 10
Return to 1 for open circuit success and 0 for failure
9.2.18 Mass MEMory subsystem commands
The Mass MEMory subsystem commands are used for file storing and load.