name suffix is automatically generated, and there is no need to input the suffix;
After the input is confirmed, a named setting file will be generated in the current directory.
4.2.4.2 File load
When the cursor moves to the file type that can be loaded, the menu is displayed as above.
Move the cursor to the location of the file to be loaded in the file list. Or directly enter the file serial
number.
Press the Load soft key, and the following confirmation dialog box will be displayed on the screen.
Load
Cancel
Pressing the soft key No will cancel the current loading operation and return to step 1.
After confirming by pressing Load, the currently selected file is loaded. After loading, it will
intelligently return to the corresponding measurement display page.
4.2.4.3 File Copy
Move the cursor to the folder or file to be copied, the menu area will display
Copy to E:\
Copy to I:\
Press the key to copy to E:, copy the file to the root directory of the external storage USB disk of
the instrument.
Press the key to copy to I:, and copy the file to the internal root directory of the instrument.
Note: Please make sure that your USB flash drive meets the standards described in this section and
is not write-protected.
To Next Page
Loading...
