Preparation 2- Setting Copy Paper 55
y Place paper with its copy side up. (The copy side may be described on the wrapping
paper.)
y For the maximum number of sheets that can be set, see P.51 “Acceptable copy
paper”.
y Fan the paper well before placing it in the drawer.
y Be sure that the paper height does not exceed the line indicated inside of the guide.
y Do not use creased, folded, wrinkled or damp sheets of paper.
7
Place paper in the drawer(s).
Make sure that a gap of 0.02" (0.04" or less in
total) is left between the paper and the side
guide for plain paper, and approx. 0.02" to 0.04"
(approx. 0.04" to 0.08" in total) for thick paper. If
the gap is insufficient, it could cause paper mis-
feeding.
A
To Next Page
Loading...
