Station
Assignment
5-8 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
204 DKT Parameters
Prerequisite Program: 200 on page 5-1
This command is used to set up DKT digital telephones station parameters.
1. Use the “DKT Parameters Record Sheet” on page D-12 to record your desired DKT settings.
2. From the Program Menu, click
Station > Assignment.
3. Click on the DKT tab (shown
right).
4. Enter a DN number in the
Primary DN field
...or click one of the following
buttons:
• List – view a summary list of
programmed DKTs.
• PDN Table View – view a
detailed list of programmed
PDNs.
• Selective Copy – Enable you
to copy some or all of the
parameters to the destination PDNs.
5. Setup the DKT by adding values to the remaining fields.
6. Click Submit.
FIELD DESCRIPTION
01 Station Type Select the Station Type. When set to Attendant, the system can support four
circuits.
Possible values: Extension (default) or Attendant
02 Key Strip Pattern This option allows you select a pre-defined keystrip pattern and submit it to the
digital telephone. It does not display what pre-defined keystrip (if any) has been
assigned to the telephone.
Use the Key tab screen to view or edit telephone keystrip assignments.
CAUTION! Submitting a keystrip pattern will overwrite existing keys
programmed on a telephone.
Default key strip patterns for digital telephones. The selected Pattern is applied to
the ’Key Strip Type’ parameter.
None – applies PDN to button 01 and blank to all other buttons.
Pattern 1 – applies PDN to button 01, plus line buttons and DND.
Pattern 2 – applies PDN to button 01, plus line buttons, One-Touch buttons and
DND.
Pattern 3 – applies PDN to button 01 and blank to all other buttons. (DKT3014 uses
only Pattern 1 or None).
Possible values: Pattern 1, 2 or None (default)
To Next Page
Loading...
