Installation
Step 2: Set Up LAN Connection to Strata CTX
3-8 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
Step 2C: Set Up IP Address of CTX WinAdmin PC NIC
(Windows XP)
Follow the steps below to set up PC Network settings on your CTX WinAdmin PC.
Note This setup is only for direct connection to the Strata CTX or for simple Hub or LAN connections.
For more complex LAN, WAN or Internet connections, refer to “Wide Area Networks and/or
Internet Connections” on page 3-5.
1. Click Start > Control Panel > Network and Internet Connections > Network Connections > Broadband
Connection.
2. At the Broadband Connection screen, click the Properties tab, then click on the Networking tab.
3. Select Internet Protocol (TCP/IP).
4. Click on the Properties tab.
5. Select “Use the following IP Address.”
6. In the IP address field enter
a.b.c.x
where a.b.c = 0~255 and x = 0~252.
Example: 192.168.254.x.
Note The first three octets a.b.c. have to be exactly the same as the first three octets of the CTX IP address
set in Sub-step 7 of Step 2B. X cannot be 253 or above and it cannot be equal to octet d of the CTX
TCP/IP address set in Sub-step 7 of Step 2B. This is the static IP Address of your PC.
7. Click OK and exit.
To Next Page
Loading...
