Toshiba Strata CTX - PAD Conference Assignment

System
PAD Table
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03 4-23
System
114 PAD Conference Assignment
This program enables you to assign PAD values for combinations of analog trunks and telephones in
conference.
Table 4-10 PAD Group Device Type Examples
Device Name
Device
Type
Device Number Example
DKT, SLT, ISDN, Station 1 0~99999 (PDN) if DKT device = 200, value = 1200.
ISDN Trunk 2 1~128 (Channel Group Number) if Channel Group # = 10, value = 210.
Analog Trunk, T1 Trunk 3 1~264 (Trunk Number) if Trunk # = 120, value = 3120.
Conference Bridge
4
none (Conference Bridge is only
one)
value = 4.
Music Source 5 1~15 (Music Port) if Music port = 8, value = 58.
External Paging Device 6 1~8 (Zone Relay Number) if External Paging Device = 3, value = 63.
FIELD DESCRIPTION
01 PAD Conference
Trunks
Enter the number of analog trunks using Table 4-11 “PAD Conference Table”
on page 4-23.
Possible values: 0~6 (default = 0)
02 PAD Conference
Telephone
Enter the number of analog telephones. See Table 4-11 below.
Possible values: 0~8 (default = 0)
03 PAD Conference Value Enter the desired PAD Value for the combination of analog trunks and
telephones specified in PAD Conference Trunks and Telephones above. The
value shown shows the net effect.
Note To pad is to insert loss; therefore, “negative loss” equals net gain.
Possible values: 1 = 6 dB Net Gain, 2 = 3dB Net Gain, 3 = 0dB, 4 = 3dB Net
Loss, 5 = 6dB Net Loss, 6 = 9dB Net Loss, 7 = 12dB Net
Loss or 8 = 15dB Net Loss (default = no value).
Table 4-11 PAD Conference Table
Number of Analog Telephones
0 1 2 3 4 5 6 7 8
Number of Analog Trunks
0000003366
100003336
23333366
366666
9
4 9 9 9 9 9
5
9 9 9 9
6 9 9 9