Station
Assignment
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03 5-23
Station
Page Group
502 Terminal Paging Group Assignment
Prerequisite Program: 200 on page 5-1
Assigns Primary DNs to Paging Group(s).
1. Complete the Station Data
record sheet provided on
page 5-30.
2. From the Program Menu click
Station > Assignment.
3. Click on the Page Group tab
(shown right).
4. Enter a DN number in the
Primary DN field.
...or select an existing record by
clicking one of the following
buttons:
• List – view a summary list of programmed DKTs.
• Extended List – view a detailed list of programmed DKTs.
• Copy – Enter a DN in the Primary DN field and click Copy. Enter a new DN(s) to assign existing
Paging Group settings.
5. Select the desired values. See descriptions below.
6. Click Submit.
FIELD DESCRIPTION
00 Primary DN Enter the Primary DN of the station to be assigned to Paging Groups. A station may
belong to more than one paging group.
Possible values: Up to 5 ASCII characters (default = no value)
Note You can have upto 72 paging groups in the Strata CTX100 and up to 120
paging groups in the Strata CTX670. Any software release before R1.01,
M19 supports only 32 paging groups for all systems.
01 PG01~16 PG16 Check the Paging Group(s) this station belongs too. The number of DNs that can be
assigned are 1~4 (CTX100), 1~8 (CTX670 Basic), 1~16 (CTX670 Exp.)
Possible values: check = On, unchecked = Off (default)
17 All Page Group Check this radio button to enter this station in all Paging Groups.
Possible values: check = On, unchecked = Off (default)
18 All Emergency
Page Group
Check this radio button to enter this station in all Emergency Paging Groups.
Possible values: check = On, unchecked = Off (default)
To Next Page
Loading...
