Trunks
300 Trunk Assignment
6-8 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
313 Caller ID
Prerequisite Program: 300 on page 6-6
This program assigns Caller ID circuits to the CO Line to which the circuit is connected. The ANI, DNIS,
DID formats for TI and analog DID CO Lines are also defined.
1. Complete the “Caller ID
Assignment Record Sheet” on
page D-24.
2. From the Program Menu, click
Trunk > Assignment, the click the
Caller ID tab. The Trunk Caller ID
Assignments screen displays
(shown right).
3. Enter a Trunk Number in Trunk
Index for an existing record or click
one of the following buttons:
• List – to view a summary list of
programmed Trunks.
• Copy – Enter the Trunk Number
in the Trunk Number field and click Copy to make new Caller ID trunk numbers.
4. Enter Caller ID Assignment data.
5. Click Submit.
10 External Ring Repeat This option determines what ring signal is sent to telephones when a line rings
the telephone. Select CO Ring Repeat (“Supplied” in older versions of
software) to use the ring signal supplied by the CO or Centrex line. Select CTX
Ring (“Not Supplied” in older versions of software) to use the standard ring
signal supplied by the CTX.
Important! CTX Ring must be used on all DISA lines for proper ringing
operation.
Possible values: CO Ring Repeat (default), CTX Ring
11 DTMF Back Tone Select DTMF Back Tone type.
Possible values: Padded, DTMF Tone (default) or No Tone
12 Hunt Order Change the trunk hunting order sequence for this Trunk.
Possible values: 1~264 or Last One (default = 1)
13 Immediate Cut-Through This option should be enabled on a line only if the talk-path must be established
immediately after seizing a selected outgoing line.
Example, a line connected to a Central Office Ringdown circuit.
Possible values: Enable, Disable (default)
CAUTION! This option will bypass Destination Restriction and
E911 digit analysis. Do not enable this option on a
line where these functions are required.
This option is available only on ground and loop, analog or T1 circuits. It should
not be enabled for Tie, DID, ISDN and QSIG lines.
Available with CTX R1.02, MA217 and above software.
FIELD DESCRIPTION
To Next Page
Loading...
