Toshiba Strata CTX - Display Version

Telephone Button Programming
900 Series Programs
Strata CTX Programming - Part 3:Telephone Button Programming 04/03 13-95
Telephone Button
Programming
➤ To access programming parameters
1. Press
)% to choose Initialize Level 1 or 2.
2. Press
+ROG twice to initialize.
Important! Choosing Initialize Level 1 without installing a SmartMedia Card deletes all programmed
data and returns your Strata CTX to factory default settings. All previously programmed
data is lost.
Restoring Data from SmartMedia
When initializing with Level 1 you can restore custom data that was previously programmed and stored on
a SmartMedia card. To do so, follow the steps below.
1. Install a SmartMedia card that contains the Prgdata directory with the
default.dat file. The default.dat
file contains your custom settings and can be created by running Data Backup. See “Data Backup” on
page 13-103.
2. After installing the SmartMedia card, run System Initialization using Initialize Level 1.
Restoring data from the SmartMedia card may take an hour or more. To verify completion of the restore
process access, the Programming Mode from a telephone and enter your password. If the system enables
you to continue, the data restore process is complete.
Note During the restore process, the telephone LCD may display date and time data. This does not
necessarily indicate completion of the restore process.
Display Version
This program enables you to view current software versions for the Strata CTX system and installed
options.
• Active – As the name implies, this is the current active software operating the Strata CTX system.
• Standby – This is a software version released prior to the active version. It acts as a backup in the event
problems are experienced by the Active version.
Program Number(s): 901
Prerequisite Program:
None
Reference: None
Access Sequence: Login to programming mode from your telephone button pad:
+ROG✱✱✱✱✱.
At the PASSWORD= prompt, Enter your password and press+ROG.
At the PROG= prompt enter  and press +ROG.
FB Name FB Summary Value LCD Prompt
Version
Number
Active
01 Display Active side software version and
installed options.
As the name implies, this is the current active
software operating the CTX system.
6~31 digits Installed Version
Version
Number
Standby
(CTX670 only).
02 Display Standby side software version and
installed options.
This is a software version released prior to
the active version. It acts as a backup in the
event problems are experienced by the
Active version.
Installed Version