Services
Least Cost Routing/Destination Restriction
9-8 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
LCR Assignment
Programs Used: 520, 521 and 522
User access to LCR is determined by programming the following:
• 103 COS Assignment – 29 LCR Feature (see page 4-9) enables access to LCR COS.
• 200 Station Assignment – 07 LCR Group (see page 5-2) assigns a station to an LCR Group.
• 304 ILG Assignment – 23 LCR Group(see page 6-3) assigns an LCR Group to an ILG.
Note Appropriate COS, DRL and FRL assignments must be made to all LCR stations and trunks.
1. Complete the “LCR Assignment
Record Sheets” on page D-42.
2. From the Program Menu, click
Services > LCR/DR > Assignment.
3. Enter Program 520 data.
4. Enter Program 521 data.
5. Enter Program 522 data.
Note For steps 3~5, complete“LCR
Assignment Record Sheets” on
page D-42.
6. Click Submit.
520 LCR Local Route Plan Assignment
Prerequisite Program: None
There are 64 LCR route plans. This assignment is used to select which LCR route plan should be used to
route local calls. The Local Route Plan, which must be defined in the route definition assignment,
determines which CO line group is used for local outgoing calls.
FIELD DESCRIPTION
01 Local Area Code Enter the area code for the dialing area in which the system is installed. This is
the area code for the Central Office (CO) that provides local CO lines to the
system. If no data is entered in this field, any previously programmed data is
lost.
Possible values: 3 digits (default = no value)
02 Local Route Plan Enter the LCR Route Plan number that should be used to route local calls.
Local calls are made by dialing 7-digit public telephone numbers that do not
require an Area Code. There are 64 LCR Route Plans from which to choose.
Possible values: 1~64 (default = 1)
To Next Page
Loading...
