Trunks
304 Incoming Line Group
6-2 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
304 Incoming Line Group Assignment
Prerequisite Program: None
This assignment is used to configure ILGs only, OLGs are configured in the Outgoing Line Group
Assignment 306. The same line can be placed in an ILG and OLG.
FIELD DESCRIPTION
00 Group Number Enter the group number of the line group that should be configured.
Possible values: 1~32 (CTX100), 1~50 (CTX670 Basic), 1~128 (CTX670
Exp),
(default = no value)
01 Group Type Select the ILG Type.
Possible values: Analog (default) or ISDN
02 Trunk Type Select the Trunk Type.
Possible values: CO (default) or Tie
03 Service Type Select CO Trunk Service Type.
Possible values: DID or DIT (default)
04 Private Service Type Select the Tie Trunk Service Type. This field is required when Trunk Type is set
to Tie.
Possible values: Standard (default) or QSIG
05 GCO Key Number Select ILG GCO Key Group for DIT mode (see Trunk Type above). The same
GCO cannot belong to different ILGs.
Possible values: 0~32 (CTX100), 0~50 (CTX670 Basic), 0~128 (CTX670
Exp),
(default = 0)
06 Pooled Key Number Select ILG Pooled Line Key Group for DIT mode. The same Pooled Line Group
cannot belong to different ILGs.
Possible values: 0~32 (CTX100), 0~50 (CTX670 Basic), 0~128 (CTX670
Exp),
(default = 0)
07 COS Select Day 1, Day 2 and Night Values.
Possible values: 1~32 (default = 1)
08 DRL Select Day 1, Day 2 and Night Values.
Possible values: 1~16 (default = 1)
09 FRL Select Day 1, Day 2 and Night Values.
Possible values: 1~16 (default = 1)
10 QPL Select Day 1, Day 2 and Night Values.
Possible values: 1~16 (default = 1)
11 DID Digits Select number of DID digits received from CO.
Possible values: 0~7 (default = 0)
12 Speech/3.1 KHz Select Bearer Capability 3.1 KHz Audio or Speech.
Possible values: Audio (default) or Speech
To Next Page
Loading...
