Trunks
304 Incoming Line Group
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03 6-3
Trunks
13 Ringing Timer Delay 1 Select time to ring the Delay 1 destination.
Possible values: 1~60 sec. (default = 12)
14 Ringing Timer Delay 2 Select time to ring the Delay 2 destination.
Possible values: 1~60 sec. (default = 24)
15 Interdigit 1 Timer Select Interdigit 1 timer value.
Possible values: 1~180 sec. (default = 15)
16 Interdigit 2 Timer Select Interdigit 2 timer value.
Possible values: 1~180 sec. (default = 5)
17 Auto Camp-on Select in box to toggle Automatic Camp-on.
Possible values: On (default) or Off
18 Calling Number ID Select Calling Number Identification source.
Possible values: User Provided (default) or Network Provided
19 Intercept Enable Intercept. A call is transferred to a special destination called intercept
position when the destination of a trunk line call is not determined with DID,
DIT or DISA. Intercept is also activated when the destination is determined, but
the call cannot be terminated due to a defect or an incorrect number. If the
system has a simplified attendant console, the Attendant Console is usually
specified to terminate the call. This function ensures termination of a trunk line
call.
Possible values: Enable or Disable (default)
20 Send Dial Tone Enable Send Dial Tone.
Possible values: Enable or Disable (default)
21 TGAC Override Enable Trunk Group Access Code (TGAC) override.
Possible values: Enable or Disable (default)
22 Network COS Enter the Network COS number.
Possible values: 1~32 (default = 1)
23 LCR Group Enter the LCR Group number. Calls from this ILG cannot tandem if this field is
not entered.
Possible values: 1~16 (default = 1)
24 Change COS Override
Code
Enable authority to change COS Override Code.
Possible values: Enable or Disable (default)
25 Register Speed Dial
Codes
Enable authority to create system speed dial codes.
Possible values: Enable or Disable (default)
26 Originator Invoke OCA Enable authority for the originator of a call to invoke OCA when encountering a
busy station.
Possible values: Enable or Disable (default)
27 Senderized Tone Mode Send DTMF tones as a complete number rather than digit-by-digit.
Possible values: Dial Tone (default), Entry Tone or Silence
FIELD DESCRIPTION
To Next Page
Loading...
