Toshiba Strata CTX - Data Backup

Telephone Button Programming
900 Series Programs
Strata CTX Programming - Part 3:Telephone Button Programming 04/03 13-103
Telephone Button
Programming
1. Press )% to view parameter. The MAC Address is view only and cannot be changed.
2. Press
+ROG (twice) to exit to the 352*= prompt.
3. Enter another program number to continue programming or press
+ROG again to exit programming
mode.
Data Backup
This program enables you to Back up system data to a SmartMedia card.
Program Number(s): 910
Prerequisite Program:
“Format/Unmount SmartMedia” on page 13-101
Reference: None
Access Sequence: Login to programming mode from your telephone button pad:
+ROG✱✱✱✱✱.
At the PASSWORD= prompt, Enter your password and press+ROG.
At the PROG= prompt enter  and press +ROG.
Note Before running this program, make sure the SmartMedia card is properly formatted. See “Format/
Unmount SmartMedia” on page 13-101 for more details.
1. Press
)% to enter your Backup choice. Press the 6FUROO or 3DJH button to view your selection
options.
2. Press
. )% and )% should blink green.
3. Press
+ROG to execute. Press +ROG again to Cancel. This program stops running if you exit
programming mode from your telephone.
FB Name FB Summary Value LCD Prompt
Backup Function 01 Start and Stop system backup.
Note Restore function is not operational
and should never be executed.
Use System Initialize (Program
900) Level 1 to restore system
backup.
1:Backup
2:Restore (Do not
use. See Note on
left).
3:Cancel
1:BACKUP
2:RESTORE
3:CANCEL
Numbers 02 The number of data blocks. This number
varies depending on the amount of
programming the system contains.
Variable ALL NO=
Current Number
03 This number increments as the backup
progresses. When the backup is complete
this number should match the total number
of data blocks displayed in Numbers
()%).
Variable CUR NO=
Backup State
04 All_Ok – Backup completed with no errors.
Partial_Ok – Backup has completed with
errors.
NG – Backup has failed.
Cancel – Cancel Backup.
Importing – Program data is being
restored.
Exporting – Program data is being sent out.
1:normal end all
2:normal end part
3:abnormal end
4:cancel
5:importing
6:exporting