Services
Networking
9-46 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
514 SMDR for OLG Assignment
Prerequisite Program: None
This command assigns SMDR parameters for OLGs.
577 Caller History
Prerequisite Program: None
Accounting Codes need to be specified for the number of digits that are expected to be used for registering
the number. This allows the dialing within the system to proceed automatically once the correct account
code is dialed, the following numbers are then dialed digits used for making the phone call. A second
length is provided to allow the number of digits to be used for verification of the code to be less than the
total code entered, thus the code may contain two parts, one required and one part optional to the user.
1. Complete the “Call History Record
Sheet” on page D-51.
2. From the Program Menu, click
Services > Miscellaneous > Behind
Connection.
3. Click Submit.
FIELD DESCRIPTION
00 Outgoing Line Group
(OLG)
Specify the OLG for which to set SMDR parameters.
Possible values: 1~32 (CTX100), 1~50 (CTX670 Basic),
1~128 (CTX670 Exp.)
02 Outgoing Records Generate records for outgoing calls. SMDR Record Display must be Enabled.
Possible values: Enable (default) or Disable
03 Charged Station Apply the SMDR record of a transferred call to its source or its destination.
Possible values: Source (default) or Destination
FIELD DESCRIPTION
Ckt Type/Number Enter the Circuit Type and number. See the Table 9-1 below.
Possible values: Up to 6 digits (default = no value)
01 Primary DN Enter Station DN to store call history data.
Possible values: Up to 5 digits (default = no value)
To Next Page
Loading...
