System
105 System Data
4-12 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
105 System Data
Prerequisite Program: None
This command assigns system settings for your Strata CTX.
1. From the Program Menu click
System > System Data. The
System Data Assignment screen
displays (shown right).
2. Enter System Parameter data
using the table below.
3. Click Submit.
FIELD DESCRIPTION
01 Executive Override Enable break in warning tone for Executive Override.
Possible values: Enable (default) or Disable
02 Station MOH Select MOH for private lines and stations.
Possible values: Quiet Tone, External 1 (default), External 2, External 3,
External 4, External 5, External 6, External 7, External 8,
External 9, External 10, External 11, External 12, External
13, External 14 or External 15
03 Ring Transfer Tone Select tones for the transferred party to hear after a ringing transfer takes
place.
Possible values: RBT (default) or MOH
04 Transfer Privacy Transfer Privacy enabled: CO line buttons that have multiple appearances will
only flash and ring on the transferred-to telephone; the same CO line button on
other telephones will be red-busy.
Transfer Privacy Disabled: CO line buttons that have multiple appearances will
flash and ring on all telephones that have the CO line button appearance.
Possible values: Enable (default) or Disable
05 Privacy Override Enable Privacy Override Attendant Monitor warning.
Possible values: Enable or Disable (default)
06 Credit Card Code Enter Service Indentifier for Credit Card Calling. If no value is entered in this
field any previously programmed data is lost.
Possible values: Up to 32 digits (default = no value)
07 Credit Card Digits Enter the Minimum Dial Digits for Credit Card Calling.
Possible values: 1~66 (default = 21)
To Next Page
Loading...
