Telephone Button Programming
900 Series Programs
Strata CTX Programming - Part 3:Telephone Button Programming 04/03 13-105
Telephone Button
Programming
Note Before running this program, make sure the SmartMedia card is properly formatted. See “Format/
Unmount SmartMedia” on page 13-101 for more details.
1. Press
)% to enter your Backup choice. Press the 6FUROO or 3DJH button to view your selection
options.
2. Press
. )% and )% should blink green.
3. Press
+ROG to execute. Press +ROG again to Cancel. This program stops running if you exit
programming mode from your telephone.
Make Busy Control
When an error occurs in hardware resources used for a station or a line fails, this feature makes them busy.
The station or line PCB can be disabled temporarily to perform maintenance or parts replacements as well.
This program is only available in the telephone button programming mode.
Program Number(s): 912
Prerequisite Program:
Format SmartMedia Card
Reference: None
Access Sequence: Login to programming mode from your telephone button pad:
+ROG✱✱✱✱✱.
At the PASSWORD= prompt, Enter your password and press+ROG.
At the PROG= prompt enter and press +ROG.
At the CABINET= prompt enter the Shelf number.
Note The Shelf number is entered in “XX” format where Shelf is a two digit value from 01~07
corresponding to the Strata CTX Cabinet number. See “Program Button LEDs” below for a
description of the LED display.
1. Press
)%~)% to enter your Make Busy selection for the appropriate Slot in the Cabinet entered in
Access Sequence above.
Note The slot to which your programming phone is connected can not be set to Make Busy.
2. Press
+ROG to execute.
3. Press
+ROG again to return to CABINET= prompt.
4. Press
+ROG to return to the PROG= prompt.
FB Name FB Summary Value
Equipment 00 Enter Cabinet Number 01~07 (value=xx)
Slot #1 01
Enter or
1: Set make busy
2: Clear make busy
Slot #2
02
Slot #3 03
Slot #4 04
Slot #5
05
Slot #6 06
Slot #7 07
Slot #8
08
Slot #9 09
Slot #10 10
To Next Page
Loading...
