Operation
System Setup
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03 10-3
Operation
901 Display Version
Prerequisite Program: None
This program enables you to view the Active and Standby software versions installed on the Strata CTX
system processor.
902 Set Time and Date
Prerequisite Program: None
This program enables you to change the system clock in Strata CTX.
FIELD DESCRIPTION
System Type Displays the system that is connected.
Possible values: CTX670, CTX100 (Active only).
Active Software Displays the software versions.
These fields indicate the following:
A = Indicates software for USA, Canada or Mexico.
Rx.xx = Indicates the CTX release level.
M0011.00 = The software version number.
Note The Active software does not always have to be the same as the Standby
software, although the Active and Standby software versions may be the
same when you receive it from Toshiba.
Standby Software
DTMF, BBMS, BEXS,
BSIS, Ethernet, and
Modem
The check marks in these boxes indicate the hardware that is installed on the Strata
CTX processor.
Notes
• On the CTX100:
• Ethernet means AETS is installed on ACTU.
• Modem means AMDS is installed on ACTU.
• DTMF means ARCS is installed on ACTU.
DREC Version Indicates the DTMF/ABR software.
IPL Version Indicates basic boot-up software version.
FIELD DESCRIPTION
CTX Date Set Strata CTXs current date.
• Select current date (YYYYMMDD).
Possible values: YYYY = Year, MM = Month and DD = Day
• Current Day of Week will display once the Year, Month and Day parameters
have been entered.
Possible values: Sunday ~ Saturday (Read only) (default = no value).
• Leap Year will display based on the year entered.
Possible values: Leap, Leap Next x, where x = 1, 2 or 3. X. is the number of
years since the previous leap year (Read only) (default = no
value).
CTX Time Set Strata CTXs current time (hhmmss).
Possible values: hh = hour, mm = minutes and ss = seconds (default = no value).
To Next Page
Loading...
