Toshiba Strata CTX - Regional Selection

To Next Page

To Previous Page

Telephone Button Programming

900 Series Programs

13-106 Strata CTX Programming - Part 3:Telephone Button Programming 04/03

5. Enter another program number to continue programming or press +ROG again to exit programming

mode.

Program Button LEDs

The LED blink pattern indicates the following:

• Red continuous blinking – PCB experienced a Make Busy status error.

• Red continuous illumination – PCB Make Busy Status mode is on.

• Green continuous blinking – PCB Make Busy Status mode is stand by.

• Green intermittent blinking – PCB Make Busy Status mode is idle.

Regional Selection

Set Operating region for your Strata CTX. This assignment sets built-in core LSI hardware parameters that

are not changeable with jumpers or switches. These parameters must be set unique for each country and

affect system operation.

Program Number(s): 915

Prerequisite Program:

None

Reference: None

Access Sequence: Login to programming mode from your telephone button pad:

+ROG✱✱✱✱✱.

At the PASSWORD= prompt, Enter your password and press+ROG.

At the PROG= prompt enter  and press +ROG.

1. Press )%. Enter ~. Press +ROG.

2. Press

+ROG (twice).

3. Enter another program number to continue programming or press

+ROG again to exit programming

mode.

FB Name FB Summary Value LCD Prompt

Region

Set region number. 0~2 are valid entries for

North American Operations.

0~31 (USA = 0,

Canada = 1, and

Mexico = 2).

REGION=

Other manuals for Toshiba Strata CTX