Toshiba Strata CTX - Phantom DN

Station
206 Phantom DN
5-24 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
206 Phantom DN
Prerequisite Program: 200 on page 5-1
This command assigns Phantom DN parameters.
1. Complete the “Phantom DN
Record Sheet” on page D-16.
2. From the Program Menu, click
Station > Phantom DN. The
Station Phantom DN screen
displays (shown right).
3. Enter a Phantom DN number
...or click one of the following
buttons:
• List – view a summary list of
programmed Phantom DNs.
• Copy – Enter the Phantom DN to copy data from, then click Copy and designate a Phantom DN to
copy the data too. Click OK.
4. Click Submit.
FIELD DESCRIPTION
Phantom DN Enter Phantom DN.
Possible values: Up to 5 ASCII characters (default = no value)
01 Owned PDN Set PhantomDN’s Owner Station
Possible values: Up to 5 ASCII characters (default = no value)
02 Tone/Voice First Select from Tone first, or Voice first signaling.
Possible values: Tone First (default) or Voice First
04 Display DN Enter the number displayed on the calling telephone that rings this Phantom DN
number.
Possible values: Up to 5 ASCII characters (default = no value)
This number is overridden by the number in Program 209, FB04 (if assigned) and
if the Phantom DN is in a hunt group. When calling from this Phantom DN, the
number displayed on the called telephone appears in order of priority as follows:
This number in Program 209, FB04 (if assigned) and if the PhDN is in a hunt
group.
...or this number in Program 200, FB15 (if assigned).
...or the calling telephone’s PDN.
05 System Call Forward Select the System Call Forward value.
Possible values: 0~4 (CTX100), 0~10 (CTX670 Basic),0~32 (CTX670 Exp.)
(default = 0)