Trunks
306 Outgoing Line Groups
6-4 Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03
306 Outgoing Line Groups
Prerequisite Program: None
OLG is a line selection feature which enables the use of external trunk or private line groups for outgoing
service. Assign and configure up to 128 OLGs (the same line can be placed in an OLG and an ILG).
1. Complete the “OLG Record Sheet”
on page D-22.
2. From the Program Menu, click
Trunk > OLG. The Trunk Outgoing
Line Groups (OLG) screen displays
(shown right).
3. Enter an OLG number in the Group
Number field for an existing record
...or click one of the following
buttons:
• List – view a summary list of
programmed OLGs.
• Create – Assign a new OLG
with default settings.
• Copy – Enter an OLG in the Group Number field and click Copy to make a new OLG assignment
with settings copied from the OLG entered in Group Number.
• Delete – Delete an OLG.
4. Enter Program 306 data.
5. Enter Program 531. See “531 DR Screening Table for OLG” on page 9-20 for details.
6. Enter Program 514. See “514 SMDR for OLG Assignment” on page 9-46 for details.
7. Click Submit.
28 Emergency Call Group Used to enable E911 calling across a QSIG network. The QSIG ILG is
assigned to an Emergency Call Group in the same way a station is in Program
200 FB17. Without this assignment, the call will not attempt to complete to one
of the trunks in the Emergency Group and will result in an abandoned call. See
Program 550 Enhanced 911 Emergency Call Group Assignment.
Possible values: 1~8 (default = 1)
FIELD DESCRIPTION
Group Number Enter the OLG Group number.
Possible values: 1~32 (CTX100), 1~50 (CTX670 Basic), 1~128 (CTX670 Exp),
(default = no value)
01 Group Type Select the OLG Type.
Possible values: Analog (default) or ISDN
02 Trunk Type Select the Trunk Type.
Possible values: CO (default) or Tie
FIELD DESCRIPTION
To Next Page
Loading...
