Services
Networking
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03 9-43
Services
Mapping
Programs Used: 657, 658, 659 and 660
The following programs map network and local COS, DRL, FRL and QPL settings to each other.
1. Complete the “Network Mapping
Record Sheets” on page D-50.
2. From the Program Menu, click
Services > Networking > Mapping.
3. Enter Program 657 data.
4. Enter Program 658 data.
5. Enter Program 659 data.
6. Enter Program 660 data.
7. Click Submit.
657 Network COS Mapping Table
Prerequisite Program: None
This table maps a Network COS received as part of a Traveling Class Mark to a local Class of Service for
access to local services. There is no translation of Outgoing Network COS.
FIELD DESCRIPTION
Ntwk COS Enter the Network COS to be mapped.
Possible values: 1~32 (default = no value)
01 Local COS Enter the Local COS to be used in place of the received Network COS.
Possible values: 1~32 (default = no value)
02 Off-hook Call Announce Choose whether an incoming call with this Network COS can activate OCA.
Possible values: Enable or Disable (default)
03 System Speed Dial Choose whether an incoming call with this Network COS can use a System
Speed Dial number to make an outgoing call.
Possible values: Enable or Disable (default)
04 COS Override Choose whether an incoming call with this Network COS can use Class of
Service Override.
Possible values: Enable or Disable (default)
05 TGAC Override Choose whether an incoming call with this Network COS can override local
Trunk Group Access Control. Typically an attendant function.
Possible values: Enable or Disable (default)
To Next Page
Loading...
