Strata CTX Programming Guidelines
Step 1: Use Default Auto-programming to Start Up
1-2 Strata CTX Programming - Part 1: Getting Started 04/03
Limitations
The following are the limitations of Strata CTX auto-programming.
• CTI programs are not programmed automatically.
• Strata CTX cannot configure unique LAN requirements automatically. Strata CTX’s LAN system data,
CTX IP address and Community Name are set to a default.
Note DND is only assigned on 20-button telephones.
• When the system is initialized, it takes a few minutes to recognize the mounted hardware.
• The Primary DN on the first button and DND on the last button are assigned telephone buttons; all other
buttons are not assigned automatically.
• Slot 101 must always have a BDKU, ADKU or PDKU. The BDKU is assigned if no PCB is installed.
Station and BIOU Auto-programming
Table 1-1 shows the Station and BIOU PCBs that will be recognized and set in Program 100 during auto-
programming.
Note No special assignments are set for BIOU during auto-programming.
Important! PCBs must be installed per the rules in the Strata CTX I&M manual, Configuration Chapter,
Worksheet 6 and Worksheet 7.
Table 1-1 Auto-Programming for Station and BIOU PCB Recognition (Program 100)
PCB Code PCB Name PCB Circuit Type
Parameter
Setting
Comments
000 No PCB or RRCU None or Remote Cabinets
002 RSTU
8 Standard Telephone
circuits
Standard telephone no VM interface
settings
003 PDKU2 8 Digital Telephone
PCM
Highway: 8
DKT2000 or DKT3000 without
S-OCA (DKT3000 limitations:
DKT2000, 16 character LCD display
on DKT3000, DKT3000 LCD Feature
key does not function, DKT3014
large screen LCD does not display).
004 Not used Not used
017 BDKU 8 digital telephones 8, 1B circuits
DKT2000 or DKT3000 without
S-OCA
018 BDKU1+BDKS 16 digital telephones 16, 1B circuits
DKT2000 or DKT3000 without
S-OCA
019 BIOU
Page/MOH/Relay
interface#1
No functions assigned
020 BIOU2
Page/MOH/Relay
interface#2
No functions assigned. Strata CTX
100 assigns a virtual BIOU2 into a
virtual location, Cabinet 02, Slot 05,
to provide control of the ACTU relay.
To Next Page
Loading...
