System
System Call Forward
Strata CTX Programming - Part 2: CTX WinAdmin Programming 04/03 4-15
System
System Call Forward
Programs Used: 500 and 504
Set up System Call Forward (SCF) parameters using the following programs.
1. Complete the “System Call Forward
Record Sheets” on page D-6.
2. From the Program Menu, click System >
System Call Forward. The System Call
Forward Destination screen displays
(shown right).
3. Enter Program 500 data.
4. Enter Program 504 data.
5. Click Submit.
500 System Call Forward Assignment
Prerequisite Program: None
This assignment is used to configure up to 32 system call forward patterns. Station DNs are assigned to
these patterns in the station COS assignments.
Note The Administrator programs the condition of transfer by setting Call Type, Period and Telephone
Status. Destinations 1 and 2 should be programmed after transfer conditions are set.
FIELD DESCRIPTION
00 SCF Number Select the SCF pattern number to configure.
Possible values: 1~4 (CTX100), 1~10 (CTX670 Basic),
1~32 (CTX670 Exp.), (default = no value)
01 Call Type Select the type of call that should forward in this pattern.
Possible values: CO Loop or Grd, DID, Tie, Ring Transfer and Internal
(default = no value)
02 Period Select the system time period in which this SCF pattern should operate.
Possible values: Day1, Day2 or Night (default = no value)
03 Telephone Status Select the telephone DN status that should cause this SCF pattern to operate.
Possible values: Busy, No Answer, Busy No Answer or DND (default = no value)
04 Destination 1 Select the first destination to which the call should forward.
Possible values: Up to 32 digits (default = no value)
05 Destination 2 Select an alternate destination to which the call should forward.
Possible values: Up to 32 digits (default = no value)
To Next Page
Loading...
